Help the team get basic lab equipment. These include glue, screws, and other items that are small but essential to our continued success.

Help the team get sensors necessary for autonomous flight; a Pitot tube, GPS, 3D compass. These sensors allow the autopilot system to get a sense of it's position, velocity, and orientation to make sure it can stay safe and on course.

Help the team get components necessary to build a hot wire foam cutter for wing manufacturing.

Help the team get enough aircraft-grade birch plywood to construct a new fuselage. The fuselage is cut from special 6 ply birch that is resilient enough to survive many controlled belly landings while holding our expensive on-board systems securely in place.

Help the team get the necessary components to print and assemble one fully populated custom Printed Circuit Board (PCB).

Help the team build their wings by contributing enough to build a full set of wings. Each set of wings takes between 2 to 4 weeks of work to cut, sand, lay-up, wire and monokote.

Help team get the necessary components to create a ground station. The ground station serves as the center of control at test flights for our team members to work out of. By helping us make our ground station, you are enabling the members of CUAir to work far more efficiently and professionally on our mission critical systems.